Hey all,
I got my Raspberry Pi Model A in this week.
I haven’t had the chance to put the board through it’s paces yet. I was a little surprised to see they are only shipping with 256MB of RAM, as I figured it would cost more to keep two supplies of RAM chips in stock, but I’m not complaining.
It did overclock to turbo mode, and it ran the same PiMAME SD card from a Model B without any problems which makes me happy. If you don’t need ethernet on board, and don’t mind using a USB hub for everything, this is the board for you.
PCSX_ReARMed
I’ve updated the binaries. The error shouldn’t be appearing anymore.
For those who have used PiMAME, you’ve seen that Playstation emulation is included. If you don’t use PiMAME, and just want the binaries to run on your own Pi, here they are.
To download & run:
- Type in console: wget http://sheasilverman.com/rpi/raspbian/pcsx_rearmed_22042013.tgz
- tar zxfv pcsx_rearmed_22042013.tgz
- cd pcsx_rearmed
- ./pcsx
- Select your game and have fun!
Pingback: Friday Post: Raspberry Pi Model A and New PCSX_ReARMed Binaries | Raspberry World
./pcsx
i got this
Inconsistency detected by ld.so: dl-version.c: 230: _dl_check_map_versions: Assertion `needed != ((void *)0)’ failed!
what can i do?
I’ve updated the binaries. The error shouldn’t be appearing anymore.
now，i can play ps_game as same as pimame-image,
but i have the same issue with both system:
after about 10minutes,
the ps-emu lost “up” or “down”,
i cant control “up”,i already set “up”,i can set it again,
but cant use “up” until restart it.
its very strange
today i reinstalled raspbian and tried again,
this issue disappeared 🙂
my monitor is 1920×1080，how to run game with 4:3 mode?
Hi. Look here:
http://www.elinux.org/RPi_Configuration
Maybe this will help:
hdmi_mode=41 1400×1050 reduced blanking
hdmi_mode=42 1400×1050 60Hz
hdmi_mode=43 1400×1050 75Hz
hdmi_mode=44 1400×1050 85Hz
hdmi_mode=45 1400×1050 120Hz reduced blanking
Hi.
At me on RasPi costs Raspbmc. I want to set PCSX_ReARMed. I set as it is written in this article. In case of the first start there was an error: “libSDL-1.2.so.0”.
I made so:
“sudo apt-get install libsdl-image1.2-dev:armhf libsdl1.2-dev libslang2-dev:armhf”
But it didn’t help.
I tried so:
“sudo apt-get install – reinstall libsdl1.2debian”
Without result.
Help me to set PCSX_ReARMed on Raspbmc.
P.S. Forgive me for my English. I from Russia, know English badly.
I have a Full HD monitor, and PCSX ReARMed stretches the image to fill the whole screen.
Is there a way to disable this, and use a 4:3 mode?
Bump? I too would like to know this
Pingback: Gaming On The Raspberry Pi |